Operating Instructions; Cleaning The Air Filter - Stihl TS 510 Cutquik Manual De Instrucciones

Operating Instructions

During break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During operation
After a long period of full-throttle
operation, allow engine to run for a while
at idle speed so that the heat in the
engine can be dissipated by flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After finishing work
Wait for engine to cool down. Drain the
fuel tank. Store the machine in a dry
place. Check tightness of nuts and
screws (not adjusting screws) at regular
intervals and retighten as necessary.
TS 510, TS 760

Cleaning the air filter

2
3
1
Soiled air filters will reduce the engine
performance, increase fuel consumption
and make it more difficult to start the
machine.
If the engine performance declines
tangibly:
: Set the choke lever (1) to the
"cold start" position l.
: Unscrew the locking nut (2) on the
filter cover.
: Remove the filter cover (3).
: Clean the area around the filter and
the inside of the filter cover to
remove all coarse dirt.
English / USA
4
5
: Grasp the prefilter (4) by the tabs
(arrows) and pull it off the main filter.
Wet prefilters must be dried before
being knocked or blown clean.
A new prefilter must be fitted if the dirt
cannot be removed in this way.
Use two prefilters alternately.
: Check the main filter (5).
It must be removed and replaced if
soiled or damaged.
The auxiliary filter must always also
be replaced together with the main
filter.
27