Stihl TS 510 Cutquik Manual De Instrucciones página 39

English / USA
Definitions
1. Rear Handle:
The support handle for the right
hand.
2. Decompression valve:
Makes starting easier.
3. Muffler:
Attenuates exhaust noises and
diverts exhaust gases in required
direction.
4. Choke Lever:
Eases engine starting by enriching
mixture
5. Air Filter:
Prevents dust and foreign matter
from entering the carburetor. (Not
illustrated)
6. Locking nut:
For removing filter cover to permit
filter to be cleaned.
7. Water attachment:
For connection of water supply for
wet cutting.
8. Tensioning segment:
For tensioning the V-belt.
9. Wheel Guard:
Guards the wheel and deflects
sparks, dust, cutting debris or wheel
fragments.
38
10. Adjusting Lever of Wheel Guard:
To adjust the wheel guard in a way
that sparks, dust, cutting debris or
wheel fragments are directed away
from the operator.
11. Abrasive Wheel:
Can either be an abrasive wheel or
a diamond abrasive wheel.
12. Front Thrust Washer:
Distributes claming pressure of
mounting nut evenly over cutting
wheel.
13. Front Handle:
Handle bar for the left hand at front
of cut-off machine.
14. Starter Grip:
The grip of the pull starter which is
the device to start the engine.
15. Fuel Filler Cap:
For closing the fuel tank.
16. Stop Swich:
Swiches the engine's ignition
system off and stops the running of
the engine.
17. Latching button:
Keeps the throttle partially open
during starting.
18. Throttle Trigger Interlock:
Must be depressed before
activating the throttle trigger.
19. Throttle Trigger:
Controls the speed of the engine.
20. Spark Plug Terminal:
Connects the spark plug with the
ignition wire.
Clutch:
Couples engine to the V-belt pulley
when engine is accelerated beyond idle
speed. (Not illustrated)
V-Belt Pulley:
The wheel that drives the V-belt and the
abrasive wheel. (Not illustrated)
TS 510, TS 760