Stihl TS 510 Cutquik Manual De Instrucciones página 26

6
5
: Press the throttle trigger
interlock (4) and
: throttle trigger (5) at the same time.
: Hold both triggers down.
: Press the latching button (6) and
hold it down.
: Then release the throttle trigger,
latching button and throttle trigger
interlock in succession =
starting throttle position.
TS 510, TS 760
4
: Place the cut-off machine on the
ground, keep a good balance and
ensure that the abrasive wheel
cannot touch any objects or the
ground.
There must not be anyone within the
swivel range of the cut-off machine.
: Press the cut-off machine firmly
against the ground, holding with the
left hand, thumb wrapped round the
handle.
: Place your right foot through the
rear handle.
English / USA
With your right hand,
: slowly pull out the starter handle as
far as the stop, then pull it through
quickly and strongly. Do not pull the
rope out completely – it may break!
Do not let the starter handle snap
back: guide it back into place so that
the starter rope is wound up
correctly.
If the engine is new, pull the starter rope
through several times to ensure that
sufficient fuel is delivered.
25