Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
8
2
9
10
:
Carefully prise the spring clip (3) off
the starter post with a screwdriver or
suitable pliers.
:
Remove the rope rotor (4) with
washer (5) and pawl (6).
:
Lever the starter rope (7) out of the
starter handle (8) with a screwdriver.
:
Remove the remainder of the rope
from the pulley and handle.
32
7
:
Thread the new starter rope (see
6
"Specifications") through the starter
handle and rope guide bush (9) from
top to bottom.
4
5
:
Pull the starter rope through the
3
pulley and secure it in the rope rotor
with a simple knot.
:
Slip the rope rotor onto the starter
post and turn it back and forth a little
until
:
the anchor loop (10) of the rewind
spring engages.
5
4
6
:
Replace the pawl (6) in the rope
rotor.
:
Place the washer (4) on the starter
post.
:
Press the spring clip (5) onto the
starter post and over the peg of the
pawl with a screwdriver or suitable
pliers. The spring clip must point to
the right, in clockwise direction as
illustrated.
TS 510, TS 760
Publicidad
Capítulos
Tabla de contenido
