Fuel - Stihl TS 510 Cutquik Manual De Instrucciones

English / USA
: Fit the abrasive wheel (4).
Note the arrows indicating the
sense of rotation on diamond
abrasive wheels.
: Fit the front thrust washer (3).
The catches of the front thrust
washer must engage in the arbor
grooves.
: Fit the hex head screw and tighten
it down firmly with the combination
wrench (or to about 30 Nm if you
use a torque wrench)
: Draw the locking pin out of the
V-belt guard.
22
Two diamond wheels of the same
type can also be used together if a
wider cut is required (e.g. for laying
induction loops in carriageways).
It is essential to ensure that the
segments are positioned exactly
side by side in such a case.
However, two composite abrasive
wheels must never be used
simultaneously, for they can break
and cause injuries as they wear
down unevenly.

Fuel

This engine is certified to operate on
unleaded gasoline and the STIHL two-
stroke engine oil at a mix ratio of 50:1.
Your two-stroke engine requires a
mixture of high-quality gasoline and
quality two-stroke air cooled engine oil.
Use mid-grade unleaded gasoline with a
minimum octane rating of 89 (R+M/2). If
the octane rating of the mid-grade
gasoline in your area is lower, use
premium unleaded fuel.
Fuel with a lower octane rating may
increase engine temperatures. This, in
turn, increases the risk of piston seizure
and damage to the engine.
The chemical composition of the fuel is
also important. Some fuel additives not
only detrimentally affect elastomers
(carburetor diaphragms, oil seals, fuel
lines, etc.), but magnesium castings and
catalytic converters as well. This could
cause running problems or even
damage the engine. For this reason
STIHL recommends that you use only
nationally recognized high-quality
unleaded gasoline!
TS 510, TS 760