Fitting / Replacing An Abrasive Wheel - Stihl TS 510 Cutquik Manual De Instrucciones

Abrasive wheels measuring
400 mm in diameter may only be
used on the special TS 760 model
specifically equipped and approved
for this purpose by the
manufacturer.
Such abrasive wheels must not be
used on any other STIHL cut-off
machines. The gear ratio of the
other STIHL cut-off machines is not
designed for abrasive wheels of this
size and may result in an
impermissibly high rotational speed
of the abrasive wheel.
The wheel may break and cause
major injuries.
In addition, the exceedingly high
load may cause bearings and cast
arms to break with the result that the
entire drive unit (bearing, guard and
abrasive wheel) is catapulted
aside – this can lead to extremely
serious accidents and injuries.
TS 510, TS 760
Fitting / replacing an
abrasive wheel
1
The engine must be switched off when
fitting or replacing an abrasive wheel –
slide control / stop switch to "0" or c
In order to block the arbor,
: slide the locking pin (1) through the
bore in the V-belt guard (turn the
arbor a short distance with the
combination wrench if necessary)
until the locking pin engages in one
of the bores behind the guard.
English / USA
: Use the combination wrench to
loosen and unscrew the hexagon
bolt (2).
: Remove the front thrust washer (3)
from the arbor together with the
abrasive wheel to be replaced.
21