Motor Management; Adjusting Carburetor - Stihl TS 510 Cutquik Manual De Instrucciones

Motor Management

Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
TS 510, TS 760

Adjusting Carburetor

The carburetor is set at the factory to
provide an optimum fuel-air mixture
under most operating conditions.
Idling and part-load emissions are
minimized by limiting the idle mixture.
Standard setting and explanation
of setting pictograms
: Check the air filter and clean it if
necessary.
: Check the spark arresting screen
and clean or replace it if necessary.
: Warm up the engine.
: Carefully screw the low speed
screw (L) down onto its seat. Then
open it 1/4 turn counterclockwise
(standard setting, L = 1/4).
English / USA
H
L
Correction of carburetor setting
for higher altitudes
If the engine runs unsatisfactorily, slight
readjustment may be necessary:
: Check standard setting
: Warm up the enging.
: Turn the high speed adjusting
screw (H) and low speed adjusting
screw (L) clockwise (leaner)
If you make the setting too lean, the
engine might be damaged as a
result of insufficient lubrication and
overheating.
29