Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
When the engine has turned over
for the first time:
:
Move the choke lever to e –
press the button of the
decompression valve again before
each fresh attempt to start the
engine.
As soon as the engine is running,
:
briefly blip the throttle trigger, the
latching button reverts to its normal
position and the engine idles.
If the carburetor has been set
correctly, the abrasive wheel must
not turn when the engine idles.
The cut-off machine is now ready for
use.
26
2
To switch off the engine:
:
Move the stop switch (2) to the stop
position c
If the temperature is very low,
let the engine warm up.
:
Briefly blip the throttle trigger when
the engine has started =
disengage starting throttle position.
The latching button reverts to its
normal position and the engine
idles.
:
Gently press the throttle trigger and
let the engine warm up.
If the engine refuses to start:
The choke lever was not returned to its
"warm start" position = e when the
engine turned over for the first time and
it has now been flooded.
:
Disconnect the spark plug terminal.
:
Unscrew and dry the spark plug.
:
Set the stop switch to c
:
Press the throttle trigger in
completely.
:
Pull the starter rope through several
times to vent the combustion
chamber.
:
Replace the spark plug and
reconnect the spark plug terminal.
:
Move the stop switch out of the stop
position c
= starting throttle position.
:
Set the choke lever to e =
"warm start" position – even when
the engine is cold!
:
Restart the engine.
If the tank has been drained
completely and then refilled:
:
Pull the starter rope through several
times until sufficient fuel is
delivered.
TS 510, TS 760
Publicidad
Capítulos
Tabla de contenido
