Husqvarna TC 449 I.E 2012 Caracteristicas - Uso - Mantenimiento página 79

ENGINE OIL REPLACEMENT AND MESH FILTERS-FILTER
CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot
engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
Remove oil filler cap (2);
-
put a drip pan under engine;
-
remove oil drainage plug (3);
-
evacuate the exhausted oil, and clean magnet on plug (3);
-
1
2
4
3
- loosen the two caps (4), and remove the two mesh
filters (5) and (6);
- check for O-rings (7) conditions. If worn, change them.
Then clean filters (5) and (6) using gasoline;
- reassembly is a reverse of removal.
- undo cap (8) and remove cartridge filter (9);
- replace filter (9), lubricate O-ring (10), and screw cap
(8);
- once filter has been replaced, refit oil drainage plug
(3), and pour the recommended quantity of oil.
5
7
7
6
7
7
SPECIFICATIONS - OPERATION - MAINTENANCE
WARNING
Start the engine to allow the oil to reach
all the points of the engine and check
the level as described in the relevant
paragraph.
To check that the oil quantity does not
exceed the "MAX" level notch, set
the motorcycle on the side stand and
check that in this position the level
goes below the "MAX" notch by look-
ing through the inspection sight glass
(1).
7 4
7 4
8
9 10 8
EN - 25