Husqvarna TC 449 I.E 2012 Caracteristicas - Uso - Mantenimiento página 86

- widen the two retaining tabs (6) and remove sub-
frame (7) with sponge (8);
8
7
6
- remove sponge (8) from subframe (7) and check if it
needs cleaning or replacing;
8
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 32
- refit all the disassembled parts in reverse order, mak-
ing sure to position filter sponge (8) with the "TOP"
wording facing up. Refit filter (5) inside guides, push
it all the way down and lock it using the clip-on fasten-
ers (4).
AIR FILTER CLEANING
Wash the filter with a specific detergent (CASTROL FOAM
AIR FILTER CLEANER or similar) then dry it fully (wash
filter with gasoline only in case of need). Plunge the filter
in special oil for filters (CASTROL FOAM AIR FILTER OIL or
similar), then wring it to drain superfluous oil.
WARNING*: Do not use fuel or a low
flash-point solvent to clean the filtering
element. A fire or explosion could result.
WARNING*: Clean the filtering element
in a well ventilated area and do not al-
low sparks or flames anywhere near
the working area.
STEERING ANGLE ADJUSTMENT
To modify steering angle, turn the adjuster screws posi-
tioned on steering tube sides, as follows:
- loosen check nut (1) and turn adjuster screw (2) until
reaching the desired angle, then tighten check nut (1)
again. Adjust angle evenly on both sides.
1
2