3M DBI Sala KF71201466 Manual Del Usuario página 10

6.0 MAINTENANCE, SERVICE, AND STORAGE
;
Do not clean and disinfect the Lanyards by any method other than described in the following "Cleaning
Instructions". Other methods may have adverse effects on the Lanyards or user.
6.1 CLEANING: Cleaning procedures for Lanyard are as follows:
• Periodically clean the exterior of the Lanyard using water and a mild soap solution. Water temperature must not
exceed 40 °C (104 °F). Position the Lanyard so excess water can drain out. Do not dry-clean. Do not iron. Clean
labels as required.
• Rinse and thoroughly air dry. Do not force dry with heat.
;
Use a bleach-free detergent when cleaning the Lanyards. Fabric softener or dryer sheets SHOULD NOT be used
when cleaning and drying the Lanyards
6.2 SERVICE: Lanyards are not repairable. If the Lanyard has been subjected to any damage or fall force, or inspection
reveals an unsafe or defective condition, remove the Lanyard from service and discard.
6.3 STORAGE/TRANSPORT: Store and transport Lanyards in a cool, dry, clean environment out of direct sunlight. Avoid
areas where chemical vapors may exist. Thoroughly inspect the Lanyard after any period of extended storage.
7.0 LABELS
Figure 10 illustrates labels on the the Lanyards and their locations. All labels must be present on the Lanyard. Information
on each label is as follows:
Figure 10 Reference:
1
2
3
4
5
6
7
8
9
10
11
12
13
Description:
Model number
Serial number
Batch number
Address of the Manufacturer
Read these instructions before use
European standard
CE Marking of European Conformity
Number of Notified body carrying out Conformity to type
Length
Month of manufacture
Year of manufacture
Web Address of the Manufacturer
Capacity
10