Ottobock DynamicArm 12K100N Información Para El Paciente página 18

Feedback
Double vibration signal and sound
sequence (see 3.1).
2 × beep (low, low)
Charging plug
The charging plug is also suitable for bilateral amputees. It is designed such that the user can insert it into
the charging receptacle with a hand prosthesis or with their mouth.
INFORMATION
The DynamicArm can remain connected to the battery charger when the charging process is finished and
the green LED is lit. Damage to the battery caused by overcharging is not possible. Partial charging does
not decrease battery shelf life (no memory effect).
INFORMATION
The operating temparature range must be between 5 °C and 40 °C (14.0 °F and 140.0 °F).
INFORMATION
Charging is only possible at temperatures over 0 °C (32 °F). If the temperature is lower than this, char-
ging is prevented to avoid battery damage.
INFORMATION
Battery charger and AC-adapter will heat up during the charging process. This is normal.
3 Error states and feedback
Error states and feedback during operation are indicated by beeps and vibration signals.
Signal
1 × long beep,
1 × vibration
1 × long beep,
5 × vibration
2 × beep (low, low),
1 × vibration
3.1 Feedback on operating states
Various sound sequences and vibrations in the DynamicArm are used for feedback on the operating states.
18 | Ottobock
Battery charge
level
very low
insufficient
Error
Critical error
(e.g., a sensor is not opera-
tional)
Severe error
(e.g., temperature of the lifting
motor too high)
Error
(e.g., incompatible component
connected)
DynamicArm 12K100N / DynamicArm Plus 12K110N
Function
The DynamicArm stops functioning. The el-
bow lock can be released and locked manu-
ally. The functions of the connected prosthet-
ic components are not impaired.
Now all other prosthetic components also
cease to function.
Troubleshooting
Turn the DynamicArm off and on
again or, with the DynamicArm
turned on, connect the battery
charger.
If the error still occurs, please con-
tact Ottobock Myo-Service.