Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales página 18

EN
WARNING!
Always keep both hands on the drive
control levers.
When driving never let go of the drive
control levers.
Always move the drive control levers
by hand to neutral to slow or stop the
device.
Always move the drive control levers
slowly. Abrupt and hasty movements
and excessively sharp curves may lead
to involuntary movements, the device
crashing and thus to serious accidents.
Be particularly careful when reversing.
If, when driving in a straight line, the
device veers to one side, or the device
does not stay in a neutral position and
moves slightly (creeping), switch the
contact a service centre.
Note
into the neutral position [N]
Sit down on the driver's seat.
Start the engine.
Release the parking brake by pulling both drive
control levers inwards into the neutral posi-
tion [N] .
To drive away, actuate the drive control levers as
follows:
Driving straight ahead
Press the two control levers forwards evenly. The
further they are pressed forwards, the faster the
device moves.
Driving forwards in a left turn
Push both control levers forwards; the right control
lever a little further than the left one.
Driving forwards in a right turn
Push both control levers forwards; the left control
lever a little further than the right one.
Note on taking corners
The greater the distance between the two
18
Reversing in a straight line
Pull both control levers backwards evenly. The
further they are pressed backwards, the faster the
device moves.
Driving backwards in a left curve
Push both control levers backwards; the right
control lever a little further than the left one.
Driving backwards in a right curve
Pull both control levers backwards; the left control
lever a little further than the right one.
Performing a right turn around the axis – a zero
turn , or spot turn
To stop the device, bring both control levers into
the neutral position.
Push the left control lever forwards, while at the
same time pulling back the right one.
Performing a left turn around the axis – a zero
turn , or spot turn
To stop the device, bring both control levers into
the neutral position.
Push the right control lever forwards, while at the
same time pulling back the left one.
-
Note on performing a zero turn
.
badly executed zero turn can damage your
lawn.
Right or left pivot turn
To stop the device, bring both control levers into
the neutral position.
Depending on the direction, move one control
lever forwards or backwards with the other one at
neutral.
Note
The neutral wheel is locked and may cause
damage to your lawn.
Slowing or stopping the device
To stop the device, bring both control levers into
the neutral position [N].
Operation