Operation - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

EN
Check tyre pressure
Check the tyre pressure on all wheels and correct
it where necessary (for max. tyre pressure, see
tyre wall).
Adjusting the driver s seat
(depending on the design and model)
Seat with adjustment lever
Sit on the driver's seat.
Press the adjustment lever to the left and keep it
held .
Bring the seat to the desired position
the adjusting lever .
Note
When releasing the adjustment lever, make
sure the seat latches in correctly.
Seat without adjustment lever
Fold the seat forward
Remove the tommy screws [1]
seat to the desired position
Fold the seat back .
Adjusting the drive control levers
Depending on requirements, the drive control levers
can be adjusted higher, lower and longitudinally.
Height adjustment
Remove the screws [1] and nuts [3]
Push the drive control lever [2] upwards or
screws and nuts in the other pair of holes of the
mount .
Note
There are three height setting options in
total.
Longitudinal adjustment
Release the clamping screw [1]
Move the control lever [2] forwards or backwards
into the desired position
Re-tighten the clamping screw [1]
Note on adjusting the drive control lever:
position (height and length adjustment).
mately horizontal.
16
and leave
.
and move the
.
.
:
.
:
.
.
.
Note on drive control lever adjustment in
connection with seat adjustment
contact with the legs of the user.
legs or the body of the user.
Set the seat to the desired operating posi-
tion.
Setting the cutter wheels
The cutter wheels should never be lower than
6-12 mm above the ground at the lowest cutter
position. The cutter wheels are not designed to bear
the loads generated by the cutters and may have
Always move the cutting wheels so they line up
evenly.
Note
depending on the model.
Also observe the information in the operating
manual for the engine.
Note
Comply with the national/municipal regula-
tions concerning the times when the appli-
local authority).
Switching the headlights on/off
(optional - depending on the model)
Switching on
The headlights [P] come on as soon as the
ignition key is turned from the STOP position
towards /
Switching o
in the STOP position /
-
-

Operation

Attention!
.
.
Operation