Removing/Installing And Adjusting The Cutter Deck - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

EN
Once a season
Lubricate all rotating and bearing points (operating
lever, height adjustment of the cutter deck, etc.)
with several drops of light oil.
Clean the spark plugs and set the electrode gap
or replace the spark plug (see engine manual).
The rear axles must be lubricated with a spe-
cial-purpose, water-repellent grease by a service
centre.
Have the cutter deck repaired only by a service
centre.
Arrange for the device to be checked for correct
operation and safety by a service centre.
Note
the condition of the cutter deck V-belt.
Removing/installing and adjusting the
cutter deck
WARNING!
Risk of injuries or material damage
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
Remove the ignition key and the spark-
plug connectors.
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
Never reach into the rotating cutter
blades.
Wear protective gloves.
Only have repair and maintenance
work and the replacement of safety
specialist or a specialist service centre.
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
WARNING!
The suspension/lifter is spring-supported
and can spring back upwards once the
cutter deck is separated from the lifter.
Removal and installation must only be
performed by a service centre.
24

Removing/installing and adjusting the cutter deck

Adjusting the cutter deck
Park the device on an even surface and switch the
parking brake on.
Note
Before aligning the cutters check the tyre
When mowing does not appear to be parallel to the
lawn the cutters can be aligned.
Adjusting the lateral cutting mechanism
level
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters transverse to the
drive direction.
Measure the distance between the ground and the
ends of the two outer cutters.
The distance should be equal at all times. If
necessary, you can set the correct level as
follows. Perform the adjustment on the left or right
adjustment segment [1] of the cutter deck:
Release the locknuts [2].
To adjust the level, screw the adjusting screw [3]
out or in until the level is correct.
Re-tighten the locknuts (77 Nm tightening torque).
Note
rect it as necessary.
Adjusting the cutter deck level from front to
rear
Note
Park the device on an even surface and switch the
parking brake on.
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters parallel to the drive
direction.
Measure the distance between the ground and the
end of the right cutter.
The blade end at the front should be about 2-6 mm
lower than the rear blade end. You may have to
Remove the protective cover [1] at the pitch arm.
Release the locknuts [2] in an anti-clockwise
direction.
To set the level, screw the nuts [3] in or out.
Re-tighten the locknuts (77 Nm tightening torque).
Fasten the protective cover back onto the pitch
arm.
-
[1] as follows: