Abicor Binzel iCAT Instructivo De Servicio página 59

iCAT
6.9 Attaching the ROBO WH torch neck
1
1
ROBO WH torch neck
2
Hand lever
Fig. 14 Attaching the ROBO WH torch neck
NOTICE
• Do not change the hand lever position during the change procedure! This will result in
malfunctions. The open knife will cause the pre-tensioned welding wire to expand and to
become cut off when actuated next. These wire pieces will block the locking mechanism
and inevitably lead to failures of the entire system!
1 Insert hand lever (2) through the sealing lips of the clamp clip (4).
2 Move hand lever (2) forward toward the torch neck (1) through the pressure point as far as
it will go.
3 Insert torch neck into changeable body as far as it will go.
4 Move hand lever (2) rearward through the pressure point as far as it will go and take it after
locking.
7 Operation
NOTICE
• Observe also the operating instructions of the welding components.
Due to the fact that the iCAT is integrated into the welding process of the torch, the operating
steps are performed after the respective torch has been put into operation. Please observe the
operating instructions of the respective ABIROB
welding torches.
5
3
iCAT ROBO WH
4
Clamp clip (in changeable body)
5
Changeable body
® ®
A, ABIROB GC, ABIROB
7 Operation
2
3
4
®
W, ROBO WH
EN - 25