Abicor Binzel iCAT Instructivo De Servicio página 63

iCAT
8 Mount the O-rings (6), (5) onto the compression sleeves (7).
9 Mount the balls (9), compression springs (8) and compression sleeves (7).
10Dismount the set screw (3) and gas duct (2) and check them, if necessary replace them.
11 Reinstall the fastening screw (12), washer (11) and screw (10).
12 Mount bellows (14) and retaining ring (13).
9.3 Cleaning the iCAT ABIROB
1
1
Retaining ring
2
Bellows
Fig. 17
Cleaning the iCAT ABIROB
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in particular safety
goggles.
1 Clean the iCAT ABIROB
2 Pull off retaining ring (1) and bellows (2) and clean with compressed air.
3 Remove screw (5), washer (6) and fastening screw (4) and clean them together with
compressed air.
4 Blow compressed air through the bores.
5 Reinstall the screw (4), washer (6) and screw (5).
6 Mount bellows (2) and retaining ring (1).
®
GC
2
6
®
3
iCAT ABIROB GC
4
Fastening screw
®
GC
®
GC (3) with compressed air.
9 Maintenance and cleaning
3
4
5
5
Screw
6
Washer
EN - 29