Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel iCAT Instructivo De Servicio

8 Putting out of operation

8 Putting out of operation
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the
welding system are strictly observed before putting out of operation begins.
Putting out of operation depends on the respective welding torch.
Please observe the operating instructions of the respective ABIROB
®
ABIROB W, ROBO WH welding torches.

9 Maintenance and cleaning

Regular and lasting maintenance and cleaning are the prerequisite of a long life and a trouble
free operation.
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• The maintenance intervals given are approximate values and refer to single-shift
operation.
• Always wear your personal protective equipment when performing maintenance and
cleaning work.
• When replacing the liquid-cooled ABIROB
that any coolant residues are removed from the iCAT ABIROB
EN - 26
®
A, ABIROB
®
W, ROBO WH hose assemblies, make sure
®
W, iCAT ROBO WH.
iCAT
®
GC,