Abicor Binzel iCAT Instructivo De Servicio página 66

11 Dismounting
Fault Cause
• Liner diameter too large
Gas loss
• Liner insufficiently stripped on the torch
Tab. 15
Troubleshooting
11 Dismounting
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Observe the information provided in the following chapter:
 8 Putting out of operation on page EN-26.
1 Disconnect the cable assembly (2) from the wire feeder (1) .
 Fig. 9 Axis positions on page EN-19
ABIROB
Versions
2 Unscrew threaded sleeve (2) and bellows (3), remove fastening
screw (14).
 Fig. 8 Mounting the ABIROB
ROBO
Version
 Fig. 10 Mounting the ROBO WH cable assembly on page EN-20
3 Pull cable assembly (2) out of the iCAT and remove it through the 4th axis of the robot
toward the back.
 Fig. 9 Axis positions on page EN-19
4 Disconnect torch neck and remove it.
 6.6 Attaching the ABIROB
 6.7 Attaching the ABIROB
 6.8 Attaching the ABIROB
 6.9 Attaching the ROBO WH torch neck on page EN-25
EN - 32
side
®
A, GC, W:
WH:
®
®
®
Solution
• Use a smaller liner
• Strip liner 350 mm on the torch side
®
A, GC, W cable assembly on page EN-17
A torch neck on page EN-22
W torch neck on page EN-23
GC torch neck on page EN-24
iCAT