Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 42

standards require the use of force limiting and safety devices (sensing ground
or objects in the operating area and prevent collisions in all circumstances.
The installer is required to measure impact forces and select on the control
unit the appropriate speed and torque values to ensure that the door or gate
ROGER TECHNOLOGY cannot be held responsible for any damage or injury
caused by the installation of incompatible components which compromise the
safety and correct operation of the device.
the maximum stop distance or the alternative use of the rubber deformable
control and operation and the command type and the use type must comply
type A or B command or type 1 or 2 use).
range of action of the automation system's moving parts; the direct commands
must be installed at a minimum height of 1.5 m and must not be accessible to
with a direct view to the motorised part and far from the moving parts.
dangerous areas.
Each installed device must have a visible indication of the motorised door or
subsequent revisions
OFF position and disconnect any buffer batteries before performing any
cleaning or maintenance operations.
Ensure that an adequate residual current circuit breaker with a 0.03 A threshold
installation in accordance with best practices and in compliance with applicable
legislation.
complies with current safety standards.
with grounding wire.
Only use original spare parts when repairing or replacing products.
The installer must provide the user with complete instruction for using the
42