Safety Input And Command Status (Test Mode) - Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador

13

Safety input and command status (TEST mode)

DISPLAY POSSIBLE CAUSE
The safety STOP contact is
open.
Sensing edge
nected or incorrectly connected.
Photocell FT1 not connected or
incorrectly connected.
Photocell FT2 not connected or
incorrectly connected.
Both limit switches in open con
tact state or not connected.
Door is at door closed limit
switch.
Door open limit switch absent or
not connected.
Door is at door closed limit
switch.
Door closed limit switch absent
or not connected.
If occurs with no voluntary com
faulty or one of the buttons may
be incorrectly connected.
N.B. Press TEST button to exit from the TEST Mode.
We recommend troubleshooting safety device and input status errors with "corrective action by software" only.
ACTION BY SOFTWARE
COS not con Set the parameter
used or to disable
Set the parameter
if not used or to disable
Set the parameter
if not used or to disable
PHYSICAL CORRECTIVE
ACTION
Install a STOP button (NC) or jump
er the ST contact with the COM
contact.
if not Jumper contact COS1 with contact
e Jumper contact FT1 with contact
Check connection referring to rela
e Jumper contact FT2 with contact
Check connection referring to rela
Check connection of limit switches.
Check connection of limit switches.
Check connection of limit switches.
nections to buttons.
nections to buttons.
nections to buttons.
nections to buttons.
63