Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 52

• Command and safety device status display mode
COMMAND STATUS
AP PED
PP
CH
POWER
• TEST Mode
TEST stops the door. Pressing the button again enables TEST mode.
device is activated.
door has reached the door open limit switch
NOTA
the next device is displayed. Any further alarm states are also displayed with the same logic.
Press the TEST button again to exit test mode.
• Standby mode
This mode is activated after 30 minutes with no user input. The POWER LED
Press UP + - to reactivate the control unit.
52
SAFETY DEVICE STATUS
FT1 FT2
COS1
STOP
or
or door closed limit switch
STOP.
Sensing edge COS.
Photocell FT1.
Photocell FT2.
Both limit switches.
Door open limit switch.
Door closed limit switch.
COMMAND STATUS:
The command status indicators on the display
PED = partial opening) are normally off. They
illuminates).
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments photocells
edge
relative device is in alarm state or is not connected.
is shown on the display to indicate that the overhead
.
POWER
sensing