Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 50

CONTACT
30(PP) 32(COM) Step by step mode command input (N.O.).
31(PED) 32(COM) Partial open control signal input (N.O.).
RECEIVER CARD
BATTERY CHARGER
B71/BC
BATTERY KIT
(B71/BC/INT)
or
(B71/BC/EXT)
(AGM type ONLY)
50
DESCRIPTION
The function of the control is determined by parameter
Set by default to 50% of completely open position.
–
–
at intervals until mains power is restored or until the battery voltage drops below the
the controller unit accepts no commands.
resumes the interrupted manoeuvre after 2 seconds.
WARNING! the batteries must always be connected to the electronic controller unit in
working order.
may be connected to terminal SC
the controller unit disconnects power from the accessory devices when the door is com
pletely open or completely closed.
•
•
.
(Battery Low) is shown on the display and
or
B71/BC battery charger.