Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador página 61

Enable safeguarded door closure/opening
command.
This function is NOT
• the door receives a STOP command;
• the sensing edge is activated;
• the door is completely open (due to parameters
•
Disabled. The parameter
Enabled.
(1)
After a period of time set with parameter
Enabled.
(1)
then the door closes.
after a period of time set with parameter
after a period of time set with parameter
(1)
to safety mode. The door will then complete the manoeuvre only when a command is received.
the motor is set to safety mode. The door will then complete the manoeuvre only when a command is received.
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
Warning! Restoring default settings cancels all settings made previously except for parameter
check that all parameters are suitable for the installation.
The default factory settings may also be restored using the
• Turn off the power.
• Press and hold the
• The display flashes after 4 s
• The default factory settings have now been restored.
N.B.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
is not displayed.
P1
P2
x4 s
(up arrow) and (down arrow) button until the unit switches on.
.
and ).
.
.
= .
(up arrow) and
Example
to .
61