Adjusting The Thread Tension - JUKI MO-2800 Manual De Instrucciones

Thread tension
1
3
4
3
4
5
A
B
C
Check your trial run
2
4/3 Thread OL
1. Upper looper thread (purple).
2. Lower looper thread (red).
3. Right-hand needle thread (green).
4
4. Left-hand needle thread (beige).
3
Perfect stitch formation is when both looper threads meet at the fabric
edge. The needle threads form straight stitches for a stretchy and dura-
ble seam.
Thread tension
Thread tension should be properly adjusted to suit the various types of
work.
The ideal tension setting for most fabrics and threads is between 3 and 5.
However this can vary quite considerably when special threads such as
filament, woolly nylon, buttonhole twist (cordonnet), pearl yarn or deco-
rative threads are used. Only use decorative threads in the looper. The
thread must move easily and without resistance through the looper eye.
注意
Infinitely variable adjustments can be made from 1 - 9.
Turn the dial downwards for less tension.
注意
Turn the dial upwards for more tension.
注意

Adjusting the thread tension

Turn the tension dials by quarter or half number, then test sew again
and check the result.
D
• The loops are formed on the underside.
• The loops are formed on the upper side.
E
• The right-hand needle thread forms loops on the underside.
• The left-hand needle thread forms loops on the underside.
• The edge of the fabric curls up, tension of both looper threads is
F
• The fabric puckers during sewing:
注意
注意
A
A
A
Tighten the upper looper thread tension, (purple) or loosen the lower
looper thread tension, red (A).
Tighten the lower looper thread tension, (red) or loosen the upper
looper thread tension, purple (B).
Tighten the right-hand needle thread tension, green (C).
Tighten the left-hand needle thread tension, beige (D).
too tight:
Loosen upper and lower looper thread tensions, purple and red
(E).
Loosen the right- or left-hand needle thread tension, green or
beige (F).
A
A
8
8
26