Hendi 221105 Manual Del Usuario página 7

Assembly
• WARNING! Never connect the power plug into
an electrical outlet before the appliance is fully
assembled.
1.
Position the motor unit firmly so that the OFF / ON buttons are facing you.
3.
Fit the flange onto the rim of the bowl. The ribs of the flange should be
lined up with the flat panel of the bowl. Make sure that the flange is cor-
rectly fitted.
5.
Line the lid with feeding chute with the notches in the flange.
6.
Correctly fit the pulp container with the hopper plate.
• Make sure the spout assembly is closed.
2.
Place the bowl on top of the motor unit.
4.
Lower the basket assembly into correct place, holding it by the holders.
Rotate it until its slots into correct place.
7.
Close the safety arm correctly.
The juicer will not start unless the safety arm has been closed properly
(safety switch).
Now, the appliance is assembled and ready for use.
IMPORTANT: Make sure that the
pin on the motor shaft is correct-
ly lined up with the corresponding
notch in the basket hub.
7
EN