Safety Shutoff; Open The Axon-Bus Gripping Component In An Emergency; Bluetooth Function; Beep Function - Ottobock AxonEnergy Integral 757B500 Instrucciones De Uso

Battery empty
Battery 50% charged
Battery fully charged

8.4 Safety Shutoff

The purpose of the safety shutoff is to protect the battery; it is triggered in case of:
• Excessively high or low temperature
• Overvoltage or undervoltage
• Short circuit.
After a short circuit the battery charger must be connected and then disconnected in order for the
electronics to be activated.

8.5 Open the Axon-Bus Gripping Component in an Emergency

8.6 Bluetooth Function

Pressing the button in the charging receptacle and holding for more than four seconds with the
Axon-Bus prosthetic system turned off activates the Bluetooth function of the connected Axon­
Master 13E500. The blue LED lights up. Once a connection to the PC has been successfully
established, the LED flashes blue.

8.7 Beep Function

Action
Switch on the Axon-Bus prosthet­
ic system
Press and hold the button for one to
four seconds.
Switch off the Axon-Bus prosthet­
ic system
Press the button and hold for more
than one second.
Charge the Axon-Bus prosthetic
system
Connect charging plug, charging
process starts.
Stop charging
Disconnect charging plug. Charging
ends and the Axon-Bus prosthetic
system is switched off.
Orange LED is illuminated
Yellow LED is illuminated
Green LED is illuminated
This safety function allows the Axon-Bus gripping component to be
opened regardless of the control signals present.
1) With the Axon-Bus prosthetic system switched on, press the char­
ging receptacle button and hold for approximately three seconds
until the Axon-Bus gripping component begins to open. A pulsating
beep sounds as it opens.
2) Releasing the button immediately stops the process of opening the
Axon-Bus gripping component and turns the entire Axon-Bus pros­
thetic system off.
Beep
1x long
Beep Beep
2x short 3x short
Beep Beep
1x short, pulsating
1x long
Ottobock | 15