Preparation For Use - Ottobock AxonEnergy Integral 757B500 Instrucciones De Uso

• Beeper for providing feedback on operating states
• Button for activating the Bluetooth function.
6.3 Axon-Bus Cable
The Axon-Bus cable with the three-pin receptacle (Fig. 1, item 3) is used to exchange data and
connects the respective Axon-Bus component to the battery.
6.4 Connection for 13E500 AxonMaster
Receptacle (Fig. 1, Item 4) for attaching the 13E500 AxonMaster.

7 Preparation for Use

7.1 Installation
The components are wired ready for use and cannot be separated.
In combination with the component holder, the 757B500 AxonEnergy Integral can only be moun­
ted in the forearm socket. The charging receptacle is installed by bonding it in place in the outer
socket with 617H46 Bonding Agent. Depending on space availability, the battery is secured in the
outer socket or between the outer and inner socket. When little space is available, the battery is
laminated into the outer socket.
NOTICE
Gluing the charging receptacle with an unsuitable adhesive
► Damage to the outer socket during removal of the charging receptacle due to the use of oth­
er adhesives (e.g. Cyamet quick-drying adhesive).
→ 617H46 Bonding Agent must be used to glue the charging receptacle because the battery
and charging receptacle must be removed from the outer socket in case of a defect.
7.2 Charging the Battery
The 757B500 AxonEnergy Integral must be charged prior to initial use. The 757B500 AxonEnergy
Integral must only be charged with the 757L500 AxonCharge Integral. The charging process can
only be performed with the 13E500 AxonMaster connected.
1) Connect the charging plug of the 757L500 AxonCharge Integral to the charging receptacle.
→ The beeper will sound briefly 2 times.
→ The Axon-Bus prosthethic system is deactivated and the charging process starts automat­
ically.
2) To activate the Axon-Bus prosthethic system, disconnect the charging plug and switch on the
Axon-Bus prosthethic system.
8 Handling
8.1 Switching On the Axon-Bus Prosthetic System
► Press the charging receptacle button and hold for one second (Fig. 2, arrow).
→ The beeper emits two short signals.
8.2 Switching Off the Axon-Bus Prosthetic System
► Press the charging receptacle button and hold for more than one second (Fig. 2, arrow).
→ The beeper emits one long signal.
8.3 Determining the Battery Charge Level
The battery charge level can be queried at any time.
1. With the Axon-Bus prosthetic system switched on, press the charging receptacle button (Fig.
2, arrow) and hold for less than one second.
2. The LED is illuminated. The colour of the LED indicates the current battery charge level.
14 | Ottobock