Mounting On A Machine Table - Garant Xpent Manual De Instrucciones

5.2.2

Mounting on a machine table

DE
Spindle drive (2)
Movable jaw (1)
EN
FR
Precondition
„ The work table is clean
„ The components of the clamping system are clean.
Tools / materials required
„ Hexagon L-wrench size 5.
„ Torque wrench (100 Nm).
„ Hexagon socket size 10.
IT
Procedure
➊
Position and secure the base rail (8) on the work table of the machine.
➋
Slide the fixed jaw (6) on to the base rail (8) and clamp it in the desired position, using the two
fixing screws (5).
➌
Release the two spindle locking pins (7) on the fixed jaw (6).
➍
Insert the spindle anchor (4) into the socket provided in the fixed jaw (6) and engage the two spindle
locking pins (7) on the fixed jaw (6). These must now no longer project.
➎
Optionally a spindle extension (3) can now be inserted. To do this, open the knurled nut as far as the
stop, insert the claws of the spindle extension (3) into the claws of the spindle anchor (3) and close the
ES
knurled nuts finger tight.
➏
Fit the spindle drive (2). To do this, open the knurled nut as far as the stop, insert the claws of the
spindle drive (2) into the claws of the spindle anchor (4) or the spindle extension (3) and close the
knurled nuts finger tight.
30
Spindle extension (3)
Spindle locking pin (7)
Base rail (8)
CAUTION! Never allow the fixed and moveable jaws to project beyond the ends of the
base rail otherwise the jaws and the base rail will be damaged�
X Before applying the clamping force, check the positions of the jaws.
Spindle anchor (4)
Locking screw (5)
Fixed jaw (6)