Össur ICEROSS LOCKING Instrucciones De Uso página 9

The device can be used for prosthetic volume management to
temporarily accommodate lost distal end volume as well as to assess
distal contact while fitting a check socket.
Place the pad either in the distal end of the liner or in the distal end of
the socket.
Note: For daily care, refer to Cleaning and Care instructions.
Iceross Interface Sheath
®
The device is intended to be used for prosthetic socket donning.
The device can be worn over the liner to allow easier donning/doffing of
the socket by reducing the friction between the socket and liner.
Pull the device over the liner. When used in conjunction with a locking
liner ensure the metal pin and distal connector fully penetrates the
knitted hole to ensure the proper function of the lock.
Machine wash at max 40 °C with light-colored fabric. Do not tumble dry.
Iceross Socks
®
The device is intended to be used for accommodating residual limb
volume reduction.
The device can be worn over the liner for volume management.
If the patient experiences compromised suspension caused by residual
limb volume fluctuations, one or more sock can be pulled over the liner
to restore socket fit.
Pull the device over the liner. When used in conjunction with a locking
liner ensure the metal pin and distal connector fully penetrates the
knitted hole to ensure the proper function of the lock.
Machine wash at max 40 °C with light-colored fabric. Do not tumble dry.
REPORT OF SERIOUS INCIDENT
Any serious incident in relation to the device must be reported to the
manufacturer and relevant authorities.
DISPOSAL
The device and packaging must be disposed of in accordance with
respective local or national environmental regulations.
LIABILITY
Össur does not assume liability for the following:
• Device not maintained as instructed by the instructions for use.
• Device assembled with components from other manufacturers.
• Device used outside of recommended use condition, application, or
environment.
9