Toshiba RAV-GM901BTP-E Manual De Instalación página 19

External static pressure
When using the wireless remote controller
To set up the external static pressure, use the DIP switch on the circuit board of the wireless reception part.
For details, refer to the instruction manual of the wireless remote controller kit. Alternatively, use the switch on the
indoor micro computer circuit board as shown in the following figure and table.
* Once switched, the settings "0001", "0003", and "0006" can be changed, but to reset to "0000", you need to set
the switch to the normal (default) position and use a separately-sold wired remote controller to overwrite the
data with "0000".
SW501
35-EN
SW501-1 OFF ON OFF
SW501-2 OFF OFF ON
SET DATA 0000 0001 0003
To reset to the factory default
Switch off SW501-1 and SW501-2, connect a separately-sold
wired remote controller, and then perform the procedure for
installing a separately-sold filter on this page to set the [5d] data
to "0000"
Filter sign setting
According to the installation condition, the filter sign
term (Notification of filter cleaning) can be changed.
Follow to the basic operation procedure
1 2 3 4 5
( → → → → →
For the CODE No. in Procedure
For the [SET DATA] in Procedure
DATA of filter sign term from the following table.
SET DATA
ON
0000
ON
0001
0006
0002
0003
0004
To secure better effect of
heating
When it is difficult to obtain satisfactory heating due
to installation place of the indoor unit or structure of
the room, the detection temperature of heating can be
raised. Also use a circulator or other device to circulate
heat air near the ceiling.
Follow to the basic operation procedure
1 2 3 4 5
( → → → → →
For the CODE No. in Procedure
For the SET DATA in Procedure
DATA of shift value of detection temperature to be
set up from the following table.
SET DATA Detection temperature shift value
0000
0001
0002
0003
0004
0005
0006
– 18 –
Power saving mode
Performing settings of the power saving
mode
* When RAV-SP***2AT / RAV-SM***3AT or older is
6
).
used, the displayed setting changes, but the actual
3
, specify [01].
power level is always "75%".
4
, select the SET
Filter sign term
None
150 H
2500 H
(Factory default)
5000 H 5
10000 H
1
Push
more when the air conditioner is not
working.
, symbol flashes.
2
Push
select an indoor unit to be set.
Each time the button is pushed, UNIT No.
change as follows:
UNIT No.
6
).
1-1
3
, specify [06].
4
, select the SET
The fan of the selected unit runs.
3
Push TIME
No shift
setting of power level.
+1°C Each push of the button changes the power
level by 1% within the range from 100% to 50%.
+2°C
The factory default is 75%
(Factory default)
+3°C
+4°C
+5°C
+6°C
4
Push button.
5
Push button to complete the setting.
1
4 3 2
button for at least 4 seconds or
(left side of the button) to
UNIT No. UNIT No.
1-2 1-3
UNIT No.
1-4
buttons, to adjust the
Setting of power level in
power saving mode
36-EN