SICE S 100 PL Manual De Instrucciones página 54

- In order to prevent the machine from
being used by unauthorised personnel,
it is advisable to disconnect the power
supply plug when the machine remains
idle (switched off) for long periods.
- If the machine is connected directly to
the power supply by means of the main
electrical board without a separate plug,
install a key-operated switch or a suitable
lock-out device to restrict machine use to
authorised personnel only.
WARNING
A good grounding connection is essential
for correct operation of the machine.
NEVER connect the earth wire to a gas or
water pipe, telephone line or any other
unsuitable objects.
Check that the pressure and flow-rate pro-
vided by the compressed air system are
compatible with those required for proper
operation of the machine - see "Technical
Data" section. For correct machine opera-
tion the compressed air supply line must
provide a pressure range from no less than
8 bar to no more than 16 bar.
Connect the compressed air system by
means of a supply pipe connected to the
intake of the air treatment unit on the REAR
SIDE of the machine base.
Check that there is air lubrication oil in the
Lubricating unit; refill if there is little or no
oil. Use SAE20 oil.
The customer must provide an air cut-off
valve upstream of the air treatment and re-
gulating device supplied with the machine.
WARNING
Connection 1 should be considered as an
emergency valve to disconnect the machi-
ne from the air line (fig.6)
54
SAFETY REGULATIONS
The equipment is intended for professional
use only.
WARNING
Only one operator may work on the
equipment at a time.
WARNING
Failure to comply with the instructions and
danger warnings may seriously injure ope-
rators and any other person present near
the machine. Do not operate the machine
until you have read and understood all
the danger, warning and caution notices
in this manual.
This machine must be used only by quali-
fied and authorised personnel. A qualified
operator is construed as a person who has
read and understood the manufacturer's
instructions, is suitably trained, and is con-
versant with safety and adjustment proce-
dures to be adhered to during operations.
Operators must not use the machine under
the influence of alcohol or drugs which may
affect their capacity.
The operator must, in all cases:
- Be able to read and understand all the
1
6
User Manual S 100 PL