SICE S 100 PL Manual De Instrucciones página 84

tube valve to let out the air left between the
tube and the tyre; this prevents deflation
and any possible damage to the tube.
- Inflate, taking utmost care that the pressu-
re shown on the Pressure gauge display 17
fig. 34 NEVER exceeds the pressure levels
recommended by the tyre producer.
- Fit the cap to the valve to protect its in-
ternal mechanism from dust and ensure
an airtight seal.
- Remove and unload the wheel as de-
scribed in steps 11-12 of the "TYRE
MOUNTING" section.
1
14
17
20
84
The "Spare parts" handbook does not
authorise users to carry out work on the
machine with the exception of those ope-
rations expressly described in the user
manual. It only enables users to provide the
technical assistance service with precise
information in order to minimise delays.
The builder declines all liability for claims
22
deriving from the use of non-original spare
parts or accessories.
Any operation intended to modify the set-
ting value of the relief valves or pressure
limiter is forbidden.
The manufacturer declines all liability for
damage resulting from tampering with
these valves.
Before adjusting or servicing the machine,
disconnect the electricity and compressed
air supplies and make sure that all moving
parts are suitably immobilised.
Do not remove or modify any parts of this
equipment except in the case of service
operations.
34
When the machine is disconnected from
the air supply system, the devices marked
with the warning sign shown above may
remain pressurised.
- The filter+regulator+lubricator is equip-
ped with a semiautomatic condensation
MAINTENANCE
CAUTION
WARNING
CAUTION
WARNING
CAUTION
DANGER
User Manual S 100 PL