SICE S 100 PL Manual De Instrucciones página 71

Advice
To prevent any rim damage, the plastic
insert under the head (fig. 13) must be
replaced every 2 months or sooner, if exces-
sively worn. A spare insert is supplied with
the machine.
Information
Any noise heard when the tool head engages
with the tyre is normal. The noise is caused
by the mechanical return of the tool and
not because the tool has hit the rim. Even
if the tool does touch the rim as the tyre is
engaged, this will not damage the rim in any
way. The pressure applied is very low. If you
wish to prevent this noise, simply press the
bead breaker disc harder against the bead
when picking it up.
WARNING
Bead breaking is well known to be a dan-
gerous operation. It must be carried out
in accordance with the instructions below.
Wheel for cars, off-road and light com-
mercial
vehicles.
User Manual S 100 PL
GUIDE TO THE CORRECT
USE OF THE S 100 PL TYRE
WARNING
Read the "PRACTICAL HINTS, ADVICE AND
USEFUL INFORMATION" section above with
great care.
TYRE DEMOUNTING
WARNING
BEFORE STARTING THE DEMOUNTING
OPERATION, MAKE SURE THE MACHINE
IS SET WITH THE COLUMN TILTED FROM
THE REAR AND THE DUAL-POSITION BEAD
BREAKER SUPPORT IS NOT LOCKED.
13
CHANGER
14
71