SICE S 100 PL Manual De Instrucciones página 86

drain device. This device operates auto-
matically whenever the compressed air
supply to the machine is cut off.
Drain the condensation manually (push-
button C, fig. 35) when the level exceeds
the mark X, fig. 35.
- Clean the top plate of the turntable every
week: remove any accumulated dirt and
clean with environmentally-friendly sol-
vents.
- Monthly checks:
the bead breaking unit and the relative
travel screws with environmentally-
friendly solvents only. Lubricate.
(fig. 35) and, if necessary, top up with
non-detergent SAE20 oil to the indicated
level Z.
solvents.
transparent cover K (correct flow-rate: 1
drop of oil every 4 bead breaking cycles).
Adjust if necessary by turning the set
screw Y fig. 35.
CAUTION
Keep the working area clean.
Never use compressed air, jets of water or
solvent to remove dirt or deposits off the
machine.
When cleaning, take care not to create and
raise dust as far as possible.
86
ENVIRONMENTAL
INFORMATION
The following disposal procedure shall be
exclusively applied to the machines having
the crossed-out bin symbol
data plate.
This product may contain substances that
can be hazardous to the environment or
to human health if it is not disposed of
properly.
We therefore provide you with the following
information to prevent releases of these
substances and to improve the use of na-
tural resources.
Electrical and electronic equipment should
never be disposed of in the usual municipal
waste but must be separately collected for
their proper treatment.
The crossed-out bin symbol, placed on the
product and in this page, remind you of the
need to properly dispose of the product at
the end of its life.
In this way it is possible to prevent that a
not specific treatment of the substances
contained in these products, or their im-
proper use, or improper use of their parts
may be hazardous to the environment or
to human health. Furthermore this helps
to recover, recycle and reuse many of the
materials used in these products.
For this purpose the electrical and electronic
equipment manufacturers and dealers set
up proper collection and treatment systems
for these products.
At the end of life of your product contact
your dealer to have information on the
collection arrangements.
When buying this new product your dealer
will also inform you of the possibility to
return free of charge another end of life
equipment as long as it is of equivalent
type and has fulfilled the same functions
as the supplied equipment.
on their
User Manual S 100 PL