Publicidad
Idiomas disponibles
Idiomas disponibles
Keep the product in good working order. Check before each use for
d)
general damage or damage to moving parts (cracks in parts and
components or any other condition that may affect the safe operation
of the device). If damaged, have the device repaired before use.
Keep the product out of the reach of children.
e)
Repairs and maintenance should be carried out by qualified personnel
f)
using only original spare parts. This will ensure the safety of use.
To ensure the designed operational integrity of the device, do not
g)
remove factory-installed covers or loosen screws.
When transporting or moving the device from storage to the place of
h)
use, observe the health and safety rules for manual handling applicable
in the country where the device is used.
Avoid situations in which the device stops under heavy loads during
i)
operation. This can cause overheating of the drive elements and
consequent damage to the equipment.
Do not touch any moving parts or accessories unless the device is
j)
unplugged.
Do not tilt or transport the machine while it is in operation.
k)
Do not leave the unit unattended during operation. Turn off the
l)
machine and disconnect the spark plug wire whenever you want to
leave the work area.
Clean the device regularly to prevent permanent dirt build-up.
m)
The product is not a toy. Cleaning and maintenance must not be
n)
performed by children without adult supervision.
Do not install, remove, adjust, or service discharge gutter components
o)
or any other parts while the engine is running.
Keep all body parts and heavy objects away from the loading hopper
p)
and discharge gutter when the engine is running.
Do not put your limbs into the hopper and the chip outlet while the
q)
machine is running. This may cause your limbs to be pulled in and/or
cut off.
Do not feed metal, rocks, bottles, cans, or any other non-botanical
r)
objects into the unit.
The rotating cutting blades inside the unit can cause serious injury if
s)
touched.
Caution should be exercised during operation. The machine can eject
t)
pieces of processed material from the loading hopper or discharge
gutter.
Publicidad
