Publicidad
Idiomas disponibles
Idiomas disponibles
5) NOTE: Do not lose the spacer. When reassembling, make sure the spacer is
installed inside the impeller. Without the spacer, the rotor will collide with the
housing components.
6) Using a hexagonal wrench, remove the two socket head screws and the knife
of the device.
7) Check / turn / sharpen or replace the knife.
8) Reinstall the unit knife and tighten the socket head screws.
NOTE
• For your safety and the life of the engine, it is very important to take the time to
check the condition of the engine.
• Worn/damaged parts must be replaced/repaired before starting the unit.
• Engine oil is hazardous to health. Dispose of the oil properly.
• Used parts and fluids should be taken to the appropriate disposal/recycling
centers.
Troubleshooting
• Although regular maintenance will extend the life of the device, prolonged or
continuous use may eventually lead to the need for service to allow continued
proper operation.
• The following guide lists the most common possible problems with the device,
their causes, and remedies.
• To find out how to do most of the minor adjustments and service repairs
yourself, see the table below. Repairs or adjustments that the user is not able to
make by himself (e.g. due to a lack of specialist knowledge) should be
outsourced to the manufacturer's service department.
WARNING!
• To avoid serious injury, maintenance should only be performed with the engine
switched off.
• Before performing maintenance, always disconnect the spark plug wire and keep
it away from it to prevent the accidental starting of the engine.
Problem
Possible cause
Action
Publicidad
