Angelo Po 1N1BR2G Manual De Uso página 111

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
Important
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those in
the vicinity should be informed.
In particular, turn off the gas supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices that
might cause unexpected health and safety
hazards if turned on.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
)
Remove the knob (C).
)
Undo the screws (A) and remove the control
)
panel (B).
C
A
_inst_GB
REPLACING PARTS
REPLACEMENT OF THE BURNER NOZZLE
B
A
Also make sure that during the maintenance
procedure, that the operator is always able
to check whether the plug is disconnected
from the power outlet.
If worn parts have to be replaced, use original
spare parts only. The manufacturer declines
all responsibly for injury or damage to com-
ponents due to the use of non original parts,
or extraordinary work on the appliance which
may modify the safety requirements without
the manufacturer's authorisation. When orde-
ring components, follow the instructions pro-
vided in the parts catalogue.
Unscrew the nozzle (D) and replace it with
)
the one suitable for the type of gas in use (see
table at back of manual).
Replace the control panel (B) and the knob
)
(C)on completion of the operation.
- -
D
ENGLISH
GB