Publicidad
Idiomas disponibles
Idiomas disponibles
General Information
2.5 RECEIVING AND STORAGE
The MW500 is supplied packed in a cardboard box. On this package, there is an identification
label which is the same as the one attached to the side of the inverter.
Check if:
The identification of the MW500 matches the model purchased.
„
Any damages occurred during transportation.
„
Report any damage immediately to the carrier.
If the MW500 will not be installed soon, store it in a clean and dry location (temperature between
-25 °C and 60 °C (-13 °F and 140 °F)), with a cover to protect it against dust accumulation and
in consequence maintain the dissipation capacity of the inverter.
ATTENTION!
When the inverter is stored for a long period, it is necessary to perform the
capacitor reforming. Refer to the procedure recommended in
PREVENTIVE MAINTENANCE on page 38
10 | MW500
Section 6.4
of this manual.
Publicidad
