Publicidad
Idiomas disponibles
Idiomas disponibles
Keypad (HMIR) and Basic Programming
It is the initial status of the HMIR after the powering
„
up and of the initialization screen, with default values
The field Menu is not active in this mode
„
The main display, secondary display and bar graph
„
indicate the values of three parameters predefined
by P0205, P0206 and P0207
From the monitoring mode, when you press the key
„
ENTER/MENU, you commute to the setting mode
Level 1:
This is the first level of the setting mode. It is possible
„
to choose the parameter group using the keys
and
The main display, secondary display, bar graph and
„
measurement units are not shown in this level
Press the key ENTER/MENU to go to level 2 of the
„
setting mode - parameter selection
Press the key BACK/ESC to return to the monitoring
„
mode
Level 2:
The number of the parameter is shown on the main
„
display and its content on the secondary display
Use the keys
and
„
parameter
Press the key ENTER/MENU to go to level 3 of the
„
setting mode - modification of the parameter content
Press the key BACK/ESC to return to level 1 of the
„
setting mode
Level 3:
The content of the parameter is shown on the main
„
display and the number of the parameter is shown
on the secondary display
Use the keys
and
„
value for the selected parameter
Press the key ENTER/MENU to confirm the
„
modification (save the new value) or BACK/ESC to
cancel the modification (not save the new value). In both
cases, the HMIR returns to level 2 of the setting mode
NOTE!
When the inverter is in the fault state, the main display indicates the number
of the fault in the format Fxxxx. The browsing is allowed after the activation
of the key ESC, and the indication Fxxxx goes to the secondary display until
the fault is reset.
NOTE!
When the inverter is in the alarm state, the main display indicates the number
of the alarm in the format Axxxx. The browsing is allowed after the activation
of any key, and the indication Axxxx goes to the secondary display until the
situation causing the alarm is solved.
NOTE!
A list of parameters is presented in the quick reference of the parameters.
For further information about each parameter, refer to the programming manual
of the MW500.
26 | MW500
Monitoring Mode
Setting Mode
to find the desired
to configure the new
Figure 4.3: Operating modes of the HMIR
Monitoring
BACK
ENTER
ESC
MENU
Setting
Level 1
BACK
ENTER
ESC
MENU
Setting
Level 2
BACK
ENTER
ESC
MENU
Setting
Level 3
Publicidad
