Publicidad
Idiomas disponibles
Idiomas disponibles
Powering up and Start-up
5.3 START-UP
5.3.1 Start-Up (Using Superdrive and Default Circuit Configuration)
When there is no possible to use the HMIR to start-up the drive, it is possible to use the Superdrive
configuration software for parameters setting and default circuit configuration for start-up, as
shown in
Figure 5.3 on page
For default configuration the commands of the inverter are the following:
Speed reference is set via knob reference.
30 | MW500
30.
S1
S2 S3
S4
1
3
5
7
9
2
4
6
8
10
Figure 5.3: Default circuit configuration
Table 5.3: Default functions configurations
Function
Run/Stop
FWD/REW
Reset
LOC/REM
GND
Shield
11
13
15
17
12
14
16
18
DIx
DI1 (S1)
DI2 (S2)
DI3 (S3)
DI4 (S4)
Publicidad
