Bosch MFW3850B Instrucciones De Uso página 20

en
Control and display elements
Control and display
elements
MFW35...
Button ä
Press button ä to switch on the appliance.
The drive will start up at once.
Button ö
Press button ö to switch off the appliance.
The drive stops.
MFW36.../MFW38...
Button k
Press button k to switch on the appliance.
The drive starts running immediately with
speed 2 (fast). Press button k again to
switch off the appliance. The drive stops.
Button +
Pressing button + briefly switches
the speed of the appliance between 1
(slow) and 2 (fast). X "Speed setting" see
page 20
Pressing and holding button +
starts the reversing function. X "Reversing
function" see page 21
All models
Operation indicator
The operation indicator lights up when the
appliance is switched on. On models with
the reversing function the function indicator
flashes for as long as the + button is
pressed.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.
Cable storage compartment
The mains cable can be pulled out of the
cable storage compartment or pushed back
in again. Only ever pull the cable out as
much as is required.
20
Storage compartment
Unused perforated discs belonging to the
meat mincer can be kept in the storage
compartment and it closed with the cover.
Overload protection
To prevent serious damage to your
appliance if the base attachment is
overloaded, the agitator paddle has a
notch (predetermined breaking point). If
overloading occurs, the agitator paddle
will break at this point. A new agitator
paddle is available from Customer
Service (No. 630701). Spare parts with
a predetermined breaking point are not
covered by our warranty obligations.
Replace agitator paddle
X Fig. C
1. Release the screw in the agitator paddle
with a screwdriver (PH2) and remove
the faulty paddle.
2. Fit a new agitator paddle and screw tight
again.
Speed setting
ONLY MFW36.../MFW38...
Using the speed setting feature, the speed
can be set to 1 (slow) or 2 (fast).
Caution!
For certain applications, it is imperative
to use speed 1 (slow). Take note of the
recommended speeds! Please also refer to
table X Fig. M
■ Switch on the appliance with button k.
The appliance will run at speed 2 (fast).
■ Press button + briefly. The
appliance will switch to speed 1 (slow).
■ Press button + briefly. The
appliance will switch back to speed 2
(fast).