Bosch MFW3850B Instrucciones De Uso página 24

en
Care and daily cleaning
X Sequence of figures J
1. Hold the base unit by the carrying
handle and carefully tip up so the
drive points upwards. Possibly turn the
base unit to make the buttons easily
accessible.
2. Insert the driving shaft with the spring
element pointing down in the drive of the
base unit.
Caution!
It should be possible to push the driving
shaft down lightly with your finger. It must
not get sticky with residue from juice or
become blocked with pips or foreign bodies.
3. Fit the collecting tray onto the drive at
an angle.
4. Turn the collecting tray anticlockwise
until you hear it click into position.
5. Fit the filter insert onto the collecting
tray.
6. Fit the pressing cone onto the driving
shaft.
The citrus press attachment is now fitted to
the base unit and prepared.
Use
X Sequence of figures K
1. Cut the citrus fruits in half.
2. Place a suitable container under the
attachment.
3. Connect the mains plug. Switch on the
appliance. The drive is running.
Caution! (MFW36.../MFW38...)
After switching on, the appliance runs at
speed 2 (fast). To use the citrus press, you
must press button + once to switch
to speed 1 (slow). X "Speed setting" see
page 20
4. Position the halved citrus fruits with
the cut surface on the pressing cone
and press down. As soon as the fruit
is pressed onto the pressing cone, the
cone will rotate.
5. To finish the process, reduce the
pressure on the cone.
6. Once you have finished, switch off the
appliance and pull out the mains plug.
24
7. Hold down the release button and
turn the attachment clockwise until it
disengages.
8. Remove the attachment, take it apart
and clean all parts. X "Care and daily
cleaning" see page 24
Notes:
– To obtain the largest amount of juice,
the pressing procedure should be
repeated a few times.
– The filter insert with the pulp and pips
should be emptied as necessary.
Care and daily cleaning
The appliance, all attachments and the
relevant accessories must be thoroughly
cleaned after each use.
W Risk of electric shock!
– Disconnect the mains cable from the
socket prior to cleaning.
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
W Risk of injury!
Do not reach into the sharp blades and
edges of the shredding and slicing inserts.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
Fig. L gives an overview of how to clean
the individual parts.
■ Wipe the outside of the base unit with a
soft, damp cloth and dry off.
■ Dismantle the attachments used in
reverse order (see „Preparation" for the
relevant attachment).
■ Clean all accessories with a detergent
solution and a soft cloth/sponge or with
a soft brush.
■ Allow all parts to dry.