Power Supply (Fig. E); Console (Fig F); Explanation Of Buttons - Tunturi E-80R Recumbent Bike Manual Del Usuario

English
Adjusting the backrest height
- Loosen the backrest height adjustment knob.
- Move the backrest to the required position.
- Tighten the backrest adjustment knob.

Power supply (Fig. E)

The trainer is powered by an external power supply.
Refer to the illustration to locate the trainer's power
input.
HINWEIS
• Befestigen Sie den Transformator am Trainer
bevor Sie diese in der Steckdose stecken.
• Entfernen sie immer das Netzkabel wenn der
Trainer nicht benutzt wird.

Console (fig F)

1
2
3
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode, the display shows
the room temperature

Explanation of buttons

BACK/ STOP
- Move back to previous window
- Stop the active training
QUICK START
- Start training without present settings.
All workout information will count up.
MAIN MENU
- It will go back to main menu.
- During training, sets console in "end your workout"
mode.
USER SETTING
- Press this button to enter User/Setting mode screen
- This button is of no use during workout
MODE/ ENTER
Turn functions
- Choose workout mode in main menu
- User/setting mode option selection
- Choose working item on the setting screen
- Increase or decrease the setting value
- Adjusting target value (high/low) during workout
- Shift up or down during T-Ride™ or T-Road workout
Horizontal
- Turning clockwise to choose option rightward.
- Turning counter-clockwise for leftward
Vertical
- Turning clockwise to shift up.
- Turning counter-clockwise to shift down
Press functions:
- Sport mode confirmation
- Option confirmation under User/Setting mode
- Confirmation of working item on setting screen
- Setting value confirmation
- Screen switching between BPM-NM or BPM-W
during workout
- Screen switching between BPM-M or BPM-FT
during T-Ride™
2 2