J.P. Bowlin Sartorius Cubis II Manual página 23

Operating Design
Symbol Name
[Ionizer] button
[Leveling] button
[GLP] button
[Unit change] button
[Invalid weight value] button
[Back] button
[Up] button
[Down] button
[Confirm] button
[On | Off] key
[Zero] key
[Tare] key
[Print] key
[Change] key
22 Operating Instructions Cubis
Description
— Starts an ionization process.
— If the button is flashing: The ioniziation process is performed.
Starts a leveling process.
— Exits the GLP printout and starts printing the GLP footer.
— If the "Net total", "Totalizing" or "Statistics" application is active:
Prints and deletes the saved values and exits the application.
If the "Unit change" function is active:
— If the button is held down: Accesses the "Unit change" function
menu.
— When the button is pressed: Switches between the basic unit display
and up to 4 other units.
For conformity-assessed devices: Indicates the cause of a fault.
— In the menu:
— When the button is pressed: Returns to the previous display.
— If the button is held down: Saves the menu settings.
— When entering digits: Selects the previous digit position.
— For an active application: Exits the application and deletes the set
reference value.
— In the menu: Scrolls through the menu levels or the available
configuration values.
— When entering digits: Increases the displayed value.
— In the menu: Scrolls through the menu levels or the available
configuration values.
— When entering digits: Decreases the displayed value.
— In the main display of an active application: Accesses the display to
set the reference values.
— In the menu: Accesses the displayed menu level or confirms the
displayed configuration value.
— When entering digits: Selects the next digit position.
— In the main display of an active application: Starts the application
process and saves the set reference value.
The switch-on behavior depends on the settings, e.g.:
— If the key is briefly pressed: Switches the operating display on.
— If the key is held down: Switches the operating display off.
Zeroes the device.
Starts taring.
Exports the readouts to the integrated data interfaces.
— If a motorized draft shield is used: Opens or closes the doors on the
draft shield.
— If no motorized draft shield is used: Changes the set unit.
| MCE Models
®