J.P. Bowlin Sartorius Cubis II Manual página 56

8.3.2 Opening or Closing via Proximity Sensors
The proximity sensor works in "crossover mode":
— Left proximity sensor: Opens and closes the right-hand and the upper
door
— Right proximity sensor: Opens and closes the left-hand and the upper
door
The sensitivity of the proximity sensors can be adjusted (see
Chapter "4.8.6 Parameters in the "DEVICE/D.SHIELD" Menu", page 35).
Wearing safety gloves may inhibit the use of the proximity sensors.
Requirements
A license key has been entered to use the motorized draft shield.
Procedure
Hold your hand in front of the left or right proximity sensor. This enables
t
the door to be fully opened or closed.
8.3.3 Manually Opening or Closing a Motorized Draft Shield
Procedure
Take hold of the door handle and push in the desired direction.
t
The door is automatically fully opened or closed.
y
8.4 Leveling the Device
Leveling compensates any inclines at the device's installation site. If leveling
is necessary: The [Leveling] display flashes.
Procedure
Press the [Leveling] button.
t
The [Leveling] display flashes.
y
The device levels itself automatically using the motorized leveling feet.
y
Operating Instructions Cubis
Operation
| MCE Models 55
®