J.P. Bowlin Sartorius Cubis II Manual página 69

Cleaning and Maintenance
68 Operating Instructions Cubis
9.5 Performing a Software Update
A software update can be installed (software package) from a USB mass
storage device using the device's USB-A or USB-C connection.
Requirements
— The device is connected to the power supply.
— The USB mass storage device is formatted with file system "FAT32".
Procedure
Download the software package from the Sartorius website onto the
t
USB mass storage device. To do this, download the "Cubis
Firmware" file.
If this relates to a zip file: Unpack the software package on the USB mass
t
storage device. The files must be saved at root level. The files must not
be set aside in a folder.
Insert the USB mass storage device with the software package into the
t
device's USB-A connection.
The device emits a short acoustic signal. This confirms that the software
y
package is available and can be run.
Open the "Device Settings" / "UPDATE" menu.
t
Select the "EXECUTE?" parameter.
t
Wait until the device has performed the software update. Do not switch
t
off the device
The device performs the software update and restarts. This updates all
y
the identified components with the new firmware.
The device confirms the end of the installation process with the [FINISH]
y
display.
The device restarts.
y
The device is ready for use.
y
| MCE Models
®
MCE
®