Publicidad
Idiomas disponibles
Idiomas disponibles
Low level indicator
Refer to Fig. 4 and Fig. IPB 1, page 12.
If indicator pin appears to drop prematurely
or water is noticeable on top of follower indi-
cator, seal may be damaged.
1 Remove bolts (4, 18) and washers (19)
holding cover on reservoir.
2 Inspect reservoir gasket (21) for damage
and replace if necessary.
3 Remove entire pump, vent valve and
follower assembly from reservoir.
4 Remove retaining ring (57) from
cable assembly (58).
5 Hold indicator plug (62) with a wrench
while removing indicator nut (60).
6 Remove and replace O-ring (59).
7 For assembly, torque indicator nut (60) to
20 ft.lbf (27 Nm).
NOTE
For assembly, install long bolts
staggered with short bolts as shown.
Follower
Refer to Fig. 4 and Fig. 5 and
Fig. IPB 1, page 12. Service unit if follower
foam is damaged or fails to wipe sides of
reservoir effectively.
1 Remove bolts (4, 18) and washers (19)
holding cover on reservoir.
2 Lift entire pump, vent valve and cover
assembly out of reservoir.
3 Remove low level indicator
cable assembly (58) from weighted
follower plate (66).
4 Remove follower assembly (38) from
pump tube.
5 Remove nuts (67) and follower plate (66)
on top of follower.
6 Remove and replace follower foam (68).
7 Assemble follower by reversing the
disassembly procedure.
Follower assembly (38)
1)
64
63
1)
1)
Long bolt
10
Low level indicator
56
57
58
59
60
61
62
68
1)
67
66
65
74
73
63
1)
Fig. 4
Fig. 5
69
70
69
71
72
Publicidad
