Publicidad
Idiomas disponibles
Idiomas disponibles
System operation
When all bearings have received lubricant,
pressure rises in the system, activating the
pressure switch. When pressure switch
activates, control is reset to de-energize
solenoid valve cutting off hydraulic oil
pressure to pump and vent valve. Pump
stops, pressure vents and pressure switch
deactivates. Control begins timing toward
next lube event.
Installation
Locate unit so that electric and hydraulic
power connections are accessible.
1 Mark center locations of the six holes at
bottom of reservoir.
2 Drill six
/
in (13 mm) holes.
1
2
Use
/
in (11 mm) bolts for added
7
16
flexibility in securing reservoir to
equipment.
3 Connect lubricant outlet of pump to
system with suitable hose capable of
3 500 psi (241 bar) working pressure.
4 Connect hydraulic inlet with at least
/
in (9 mm) I. D. hose capable of at least
3
8
3 000 psi (207 bar) operating pressure.
5 Connect hydraulic return to tank
connection line with
/
in (19 mm) ID
3
4
hose or pipe.
Bare pump
assembly
Refer to 85877 operation manual 404693
for setting pump speed on 24 V
Filling reservoir
To bulk fill reservoir:
1 Attach model 80933 button head coupler
to button head connector (75) on lower
fill port.
2 Fill reservoir until grease level gauge
indicates it is full or until grease appears
at top high level port.
3 Remove button-head coupler.
WARNING
Do not overpressurize reservoir during
filling process.
Failure to comply may cause damage
to reservoir, death and/or serious
personal injury.
WARNING
Do not perform maintenance or service
prior to disconnecting all hydraulic and
electric power to pump assembly.
Failure to comply may cause death
and/or serious personal injury.
7
motor.
Publicidad
