Tenda N Serie Guía De Instalación Rápida página 10

App management
After the cloud service of the NVR is enabled and the cloud status is online, you can add and manage
the NVR through the TDSEE App.
Download the TDSEE App.
After the smartphone is connected to the internet successfully, download and install the TDSEE App
onto your mobile phone by scanning the QR code or by searching for TDSEE in Google Play or App
Store.
Ensure that the NVR is powered on and working properly.
Run the TDSEE App and follow the instructions to complete user registration. Enter the Home page,
then tap Add a device or in
Tips
To ensure that the login password of the NVR can be reset through the TDSEE App, please register using the email address you used to activate
the NVR.
Scan the QR code on the label at the bottom of the NVR or scan the QR code on the Cloud
Service page, then follow the instructions in the App.
After adding the NVR, you can remotely preview real-time video, play back the recordings and check
alarm messages through the TDSEE App.
Web management
These series of NVRs can be managed on the web UI.
Activate
If the NVR is not activated, you can activate it through the web UI. When the activation is completed, you
need to log in again.
Connect the computer to the switch or router that is connected to the NVR.
Set the IP address of the computer to an unused one belonging to the same network segment as the IP
address of the NVR but different from the IP address of the NVR.
The default login IP address of the NVR is 192.168.1.254, please set the IP address of the computer to
192.168.1.X (X indicates 2 to 253, and is unused by other devices).
the upper right corner of the home page.
- 8 -